TX-RZ 30 Miscellaneous
1. Tuner (North American and Taiwanese models)
Change the settings for Tuner.AM/FM Frequency Step (Default Value: 10 kHz / 0.2 MHz)
Select a frequency step to suit your residential area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets are deleted.2. Remote ID
Change the remote controller ID.Remote ID (Default Value: 1)
If multiple ONKYO products are installed in the same room, select the ID for the remote control used with this unit from "1", "2" and "3" to prevent interference between the unit and other ONKYO products. After changing the ID on the main unit, set the same ID on the remote controller as the main unit
with the following procedure.
While pressing and holding the MODE button, press the following buttons for approx. 3 seconds.
• To change the remote controller ID to "1": MOVIE/TV
• To change the remote controller ID to "2": MUSIC
• To change the remote controller ID to "3": GAME 3. Firmware Update
Change the settings for Firmware Update.Update Notice (Default Value: Enable)
Availability of a firmware update is notified via network.
Enable | Notify updates |
Disable | Do not notify updates |
Version (Default Value: -)
The current firmware version is displayed.Update via NET (Default Value: -)
Press ENTER to select when updating the firmware via network.
• This setting cannot be selected if you do not have Internet access or there is
no updatable firmware.Update via USB (Default Value: -)
Press ENTER to select when updating the firmware via USB.
• This setting cannot be selected if a USB storage device is not connected or there is no updatable firmware in the USB storage device.
• Wait for a while if "Firmware Update" cannot be selected. It can be selected when the network function is activated.
4. Initial Setup
Make the initial setup from the setup menu.
• Wait for a while if "Initial Setup" cannot be selected. It can be selected when
the network function is activated.5. Lock
Lock the Setup menu so that the settings cannot be changed.Setup Parameter (Default Value: Unlocked)
Lock the Setup menu so that the settings cannot be changed.
Locked | The menu is locked. |
Unlocked | The menu is unlocked. |
6. Factory Reset
All the settings are restored to factory defaults.Factory Reset (Default Value: -)
All the settings are restored to factory defaults. Select "Start" and press ENTER.
• If "Factory Reset" is performed, your settings are restored to the default values. Be sure to note down your setting contents beforehand.
Comments
0 comments
Please sign in to leave a comment.