TX-RZ50 - Rear Panel (NA)
Below, you will see an images and descriptions of all the components on the Onkyo TX-RZ50 rear panel. These images refer to the North American model only.
- DIGITAL IN OPTICAL/COAXIAL Jacks: Input TV or AV component digital audio signals with a digital optical cable or digital coaxial cable.
- TUNER AM/FM Terminal: Connect the supplied antennas.
- COMPONENT VIDEO IN Jacks: Input AV component video signals with a component video cable. (Compatible only with 480i or 576i resolution.) VIDEO IN jacks: Input AV component video signals with an analog video cable.
- Wireless Antenna: Used for WI-Fi connection or when using a BLUETOOTH enabled device. Adjust the angles according to the connection status.
- HDMI OUT Jacks: Transmit video signals and audio signals with an HDMI cable connected to a monitor such as a TV or projector.
- HDMI IN Jacks: Transmit video signals and audio signals with an HDMI cable connected to an AV component.
- ETHERNET Port: Connect to the network with an Ethernet cable.
- USB Port: Connect a USB storage device to play music files. You can also supply power (5 V/1 A) to USB devices with a USB cable.
- AC INLET: Connect the supplied power cord.
-
SPEAKERS Terminals: Connect speakers with speaker cables. Support banana plugs. Use a plug 4 mm in diameter. Y plug connection is not supported.
- GND Terminal: Connect the ground wire of the turntable.
- AUDIO IN Jacks: Input AV component audio signals with an analog audio cable.
- 12V TRIGGER OUT Jack: Connect a device equipped with a 12V trigger input jack to enable power link operation between the device and this unit.
- IR IN Port: Connect a remote control receiver unit.
- RS232 Port: Connect a home control system equipped with an RS-232C port. For installing a home control system, contact the specialized stores.
- PRE OUT Jacks: Connect to a power amplifier.
- SUBWOOFER PRE OUT Jacks: Connect a powered subwoofer with a subwoofer cable. Up to two powered subwoofers can be connected. The same signal is output from each SUBWOOFER PRE OUT jack.
-
ZONE 3 PRE/LINE OUT Jacks: Output audio signals with an analog audio cable connected to an integrated amplifier in a separate room (ZONE 3).
HEIGHT 2 PRE OUT jacks: Connect a power amplifier. -
ZONE 2 PRE/LINE OUT Jacks: Output audio signals with an analog audio cable connected to an integrated amplifier in a separate room (ZONE 2).
ZONE B LINE OUT Jacks: Simultaneously output the same audio source as the speakers (ZONE A) connected to this unit by connecting this unit to wireless headphones, wireless speaker transmitter, etc., using an analog audio cable.
Comments
0 comments
Please sign in to leave a comment.