TX-NR5100 ZONE B Playback

While performing playback in the main room (ZONE A), you can enjoy the audio of the same source in the separate room (ZONE B) at the same time.
Playing Back                                                                                 
1. Press the Q button on the remote controller and select "Audio" - "Zone B".
2. Select the audio output destination.
Off: Outputs audio only from ZONE A. "A" on the display of the main unit lights up.
On (A+B): Outputs audio from both ZONE A and ZONE B. "A" and "B" on the display of the main unit light up.
On (B): Outputs audio only from ZONE B. "B" on the display of the main unit lights up.
3. Start play on the AV component.
4. If the unit is connected to the pre-main amplifier in the separate room, adjust the volume on the pre-main amplifier. If the unit is connected to the power amplifier or ZONE speaker in the separate room, adjust the volume on the remote controller.
・ When connecting the power amplifier, set "Zone B Output Level" to "Variable" for "Speaker Setup" in the Initial Setup section ( →p120) . When setting "Zone B Output Level" from the Setup menu, press on the remote controller, and set "2. Speaker" - "Configuration" - "Zone B Output Level" ( →p99) to "Variable". If it is not set, a large volume is output and the power amplifier, speakers, e a tc. may be damaged.
If "On (A+B)" is selected as an audio output destination, you can select only the "Stereo" listening mode for ZONE A when using the 2.1 ch speaker layout. When using a speaker layout of 3.1 ch or more, you can select only the "AllCh Stereo" listening mode.