Connecting Onkyo equipment with RI terminal

Following link functions can be operated by connecting an Onkyo CD player, an RI dock, or a tuner (*) with RI terminal via an RI cable.

* The link function will not operate appropriately with other equipment such as MD player, etc. Also, part of the function may not operate even if it is connected via RI depending on the equipment.

Auto Power On: When you start playback on an equipment connected via RI while the unit is in standby mode, the unit will automatically turn on and select that equipment as the input source.

Direct Change: When playback is started on an equipment connected via RI, the unit automatically selects that equipment as the input source.

System Off: When you turn off the unit, the equipment turn off automatically.

Remote Control: You can use the unit’s remote control to control your other RI-capable Onkyo equipment, pointing the remote control at the unit’s remote control sensor instead of the equipment.

This is an example of connecting Onkyo CD player via LINE.

1. .Connect the audio pin cable to the LINE IN 1 jack.
   1. The RI link will not work properly when connected to a terminal other than the LINE IN 1.
   2. Connect the RI cable to the REMOTE CONTROL jack.
      1. When there are two RI terminals on the used equipment, the operation is the same when connected to either terminal.
   3. (North American and Continental European models) Set the RI MODE (CD) switch to LINE1

When connecting two or more RI terminals, one can be connected to this unit and the other can be connected to other equipment, allowing to link both equipment to this unit. Similarly, it is possible to increase the equipment to be linked. There is no specification for order to connect the equipment.

For other connection methods:

Connection to a CD player via DIGITAL (North American and Continental European models):

• Connect the coaxial digital cable to the COAXIAL (D1) jack
• Connect the RI cable to the REMOTE CONTROL jack
• Set the RI MODE (CD) switch to D1

Connection to an RI dock via LINE:

• Connect the audio pin cable to the LINE IN 2 jack
• Connect the RI cable to the REMOTE CONTROL jack (North American and Continental European models)
• Set the RI MODE (DOCK) switch to LINE2.

Connection to an RI dock via DIGITAL (North American and Continental European models):

• Connect the optical digital cable to the OPTICAL (D2) jack
• Connect the RI cable to the REMOTE CONTROL jack
• Set the RI MODE (DOCK) switch to D2

            
Connection to a tuner via LINE:

• Connect the audio pin cable to the LINE IN 3 jack
• Connect the RI cable to the REMOTE CONTROL jack
  • (North American and Continental European models) The link function of RI is not supported when a tuner is connected via DIGITAL. Do not connect the RI cable.