You can connect two systems, Speaker A and Speaker B, as the Speaker System. When connecting only one set, connect to the SPEAKERS A terminals. With one set, use speakers with 4 Ohms to 16 Ohms impedance.

Note that when connecting to both SPEAKERS A and B terminals, connect speakers with 8 Ohms to 16 Ohms impedance to both A and B.

Connect the speaker cable so the wires do not protrude from the speaker jacks. If the exposed wires of the speakers touch the rear panel or the + and – wires touch each other, the protection circuit will be activated.

Setup

When connected as a Speaker B System, you can output the same audio as Speaker A System by switching with A/B/A+B. Press SPEAKER A/B on the main unit to switch. The selection changes
in the order SPEAKER A, SPEAKER B, SPEAKER A+B, Off with each press.

If any of the connected speakers have an impedance of 4 Ohms or more to less than 6 Ohms, or when a Speaker B system is to be used, press SETUP on the remote controller, and set "SP Impedance" to "4 ohm".

(*)You can also connect a powered subwoofer to the SUBWOOFER PRE OUT jack to boost bass playback even more. Use a subwoofer cable for connection.