A-9150- Connecting a Turntable

This unit is compatible with turntables using either MM cartridges or MC cartridges. You will need to switch the input setting to match the type of cartridge you are using.

Use an analog audio cable to connect the PHONO (MM/MC) L/R jacks to the audio output jacks on the turntable, as shown.  A shorting pin has been inserted in the PHONO (MM/MC) L/R jack. Remove the shorting pin to connect.

Note

• Keep the shorting pin in a safe place.
• Do not insert the shorting pin in any jacks other than the PHONO (MM/MC) L/R jack. Doing so may cause the unit to malfunction.

Tip

• If the turntable has a ground wire, connect it to GND terminal.  With some turntables, connecting the ground wire may cause hum, in which case it should be disconnected.
• If your turntable has a built-in phono preamp, connect to other analog inputs such as LINE IN.