TX-NR7100 - Setup Menu - Miscellaneous
Tuner
Change the settings for Tuner.
AM/FM Frequency Step (North American models)
Default Value: 10 kHz / 0.2 MHz
Select a frequency step to suit your residential area. Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
- When this setting is changed, all radio presets are deleted.
AM Frequency Step (Australian and Asian models)
Default Value: 9 kHz
Select a frequency step to suit your residential area. Select "10 kHz" or "9 kHz".
- When this setting is changed, all radio presets are deleted.
FM Search Level (European models)
Default Value: Normal
If automatic tuning regularly stops on FM stations with weak reception when "Normal" is selected, select "Strong" so only those FM stations with strong reception are selected.
DAB Auto Scan (European models)
Default Value: -
You can run the auto scan when new DAB stations are added or when you move house.
DAB DRC (European models)
Default Value: Off
With the DRC (Dynamic Range Control) setting, you can reduce the dynamic range of DAB digital radio so that you can still hear quiet parts even when listening at low volume levels - ideal for listening to the radio late at night when you don't want to disturb anyone.
Remote ID
Change the remote controller ID.
Remote ID
Default Value: 1
If multiple ONKYO products are installed in the same room, select the ID for the remote control used with this unit from "1", "2" and "3" to prevent interference between the unit and other ONKYO products. After changing the ID on the main unit, set the same ID on the remote controller as the main unit
with the following procedure. While pressing and holding the MODE button, press the following buttons for approx. 3 seconds.
- To change the remote controller ID to "1": MOVIE/TV
- To change the remote controller ID to "2": MUSIC
- To change the remote controller ID to "3": GAME
Firmware Update
Change the settings for Firmware Update.
Update Notice
Default Value: Enable
Availability of a firmware update is notified via network.
Version
Default Value: -
The current firmware version is displayed.
Update via NET
Default Value: -
Press ENTER to select when updating the firmware via network.
- This setting cannot be selected if you do not have Internet access or there is no updatable firmware.
Update via USB
Default Value: -
Press ENTER to select when updating the firmware via USB.
- This setting cannot be selected if a USB storage device is not connected or there is no updatable firmware in the USB storage device.
- Wait for a while if "Firmware Update" cannot be selected. It can be selected when the network function is activated.
Initial Setup
Make the initial setup from the setup menu.
- Wait for a while if "Initial Setup" cannot be selected. It can be selected when the network function is activated.
Lock
Lock the Setup menu so that the settings cannot be changed.
Setup Parameter
Default Value: Unlocked
Lock the Setup menu so that the settings cannot be changed.
Locked The menu is locked.
Unlocked The menu is unlocked.
Factory Reset
All the settings are restored to factory defaults.
Factory Reset
Default Value: -
All the settings are restored to factory defaults. Select "Start" and press ENTER.
- If "Factory Reset" is performed, your settings are restored to the default values. Be sure to note down your setting contents beforehand
Comments
0 comments
Please sign in to leave a comment.