TX-8260 - Troubleshooting: Remote Controller and Display
Problems may be solved by simply turning the power on/off or disconnecting/connecting the power cord, which is easier than working on the connection, setting and operating procedure. Try the simple measures on both the unit and the connected device. If the problem isn't fixed after referring to "Troubleshooting", resetting the unit to the status at the time of shipment may solve the problem. Note that your settings will also be initialized when you reset, so we recommend that you note down your settings before doing the following.
- This unit contains a microPC for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least 5 seconds, and then plug it back in.
- We are not responsible for reparations for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.
Try restarting the unit
The issue may be fixed by restarting this unit. After switching this unit to standby, press and hold Í ON/ STANDBY on this unit for 5 or more seconds to restart the unit. (The settings in the unit are maintained.) If the issue is not fixed by restarting, try unplugging the power cords of the unit and connected devices, and then plugging them in again.
Resetting the unit (this resets the unit settings to the default)
If restarting the unit doesn't fix the problem, resetting the unit to the status at the time of shipment may solve the problem. Your settings will also be initialized when you reset, so note down your settings before doing the following.
- While holding down TUNING MODE on the main unit, press ON/STANDBY.
- 2. The unit switches to standby and the settings are reset.
Remote Controller
- Make sure that the batteries are installed with the correct
polarity. - Install new batteries. Do not mix different types of
batteries, or old and new batteries. - Make sure that the unit is not subjected to direct
sunshine or inverter-type fluorescent lights. Relocate if
necessary. - If the unit is installed in a rack or cabinet with colored
glass doors or if the doors are closed, the remote
controller may not work reliably. - After operating the Multi-zone function, the remote
controller may have switched to the mode for controlling
ZONE 2. Press REMOTE MODE MAIN to switch to the
mode to control the main room.
Display
The display doesn't light
- The display may go dim while the Dimmer is working.
Press DIMMER to change the brightness level of the
display.
Comments
0 comments
Please sign in to leave a comment.