A-9010 - Connecting Speakers

! IMPORTANT !

Connect speakers with 4 ohm to 16 ohm impedance. Connecting a speaker with a lower
impedance may damage the unit.

Refer to the illustration below to connect the unit and the right and left speakers with the speaker cables.

1. Connect the speaker to be placed on the right hand side to the SPEAKERS terminal (R), and connect the speaker to be placed on the left hand side to the SPEAKERS terminal (L)
   
2. Remove the vinyl from the tip of the speaker cable and twist the core before connecting to the terminal
3. Make correct connection between the unit’s terminals and speaker’s terminals (+ to + and - to -) for each channel
   1. If connection is wrong, a bass sound may become poor due to reverse phase
      1. Short-circuiting the i cable and j cable or contacting the cable core to the rear panel of the unit may cause failure. Also do not connect two or more cables to one speaker terminal or one speaker to several terminals.
         
      2. (North American models) When using commercially available banana plugs, tighten the speaker terminals to the end and then insert the banana plugs. It is not possible to connect by inserting the core of the speaker cable directly into the hole for a banana plug. Make sure to attach a banana plug before inserting.

For detailed explanation of the inputs and outputs on the A-9010 amplifier, see our article here - A-9010-Connection Diagram