TX-8260-Connecting Speakers
You can connect two systems, Speaker A and Speaker B, as the Speaker System. When connecting only one set, connect to the SPEAKERS A terminals. With one set, use speakers with 4 Ohms to 16 Ohms impedance.
Note that when connecting to both SPEAKERS A and B terminals, connect speakers with 8 Ohms to 16 Ohms impedance to both A and B.
Connect the speaker cable so the wires do not protrude from the speaker jacks. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated.
Setup
When connected as a Speaker B System, you can output the same audio as Speaker A System by switching with A/B/A+B. Press SPEAKER A/B on the remote control to switch. The selection changes in the order SPEAKER A, SPEAKER B, SPEAKER A+B with each press.
- If any of the connected speakers have an impedance of 4 Ohms or more to less than 6 Ohms, or when speaker systems are connected to both of the SPEAKERS A/B terminal, after completing Initial Setup, you need to make some settings in the Setup menu. Press SETUP on the remote controller, and set "3. Hardware" - "SpImpedance" to "4 Ohms".
* You can also connect a subwoofer with a built-in amplifier to the SUBWOOFER PRE OUT jack to boost bass playback even more. Use a subwoofer cable for connection. When only Speaker B is outputting audio, there will be no audio output from the powered subwoofer.
Comments
1 comment
I tried using banana plugs (on 2 separate units) and it did not work. Using bare wires works fine. So I got some adapters that have braided wires and accept banana plugs.
Please sign in to leave a comment.