TX-8260-Connecting an External Device
Digital In Connection
Connect an external device with a digital optical cable or digital coaxial cable. Note that this unit is equipped with an "Opt1Wkup feature" so that when play starts on an external device connected to the OPTICAL 1 (GAME) terminal, this unit comes on and the INPUT SELECTOR automatically changes.
- The default setting for "Opt1Wkup feature" is "Off". To enable this function, please press SETUP on the remote controller, and set "3. Hardware" - "Opt1Wkup".
- The Opt1Wkup feature does not work when the unit is in the mode for controlling ZONE 2.
-
Only PCM audio is supported for input through the DIGITAL IN OPTICAL/COAXIAL jacks. Set the audio output on the external device to output PCM.
Line In Connection
Connect an external device with an analog audio cable. You can connect a turntable that has an MM-type cartridge to the PHONO jack.
- If the turntable has a built-in audio equalizer, connect it to an LINE IN jack other than the PHONO jack. Also, if the turntable uses an MC type cartridge, install an audio equalizer compatible with the MC type cartridge between the unit and the turntable, then connect to any LINE IN jack other than the PHONO jack.
If the turntable has a ground wire, connect it to the GND terminal.
- By connecting an Onkyo component with RI jack to the unit by using an RI cable and an analog audio cable, you can link the unit’s power and input selection and enable operation with this unit’s remote controller.
- Part of the function may not operate even if it is connected via RI depending on the equipment.
- The RI linking features may not work when the unit is in the mode for controlling ZONE 2.
- When connecting an RI dock, you must rename the input selectors on the unit to make the system link work. Select the GAME input selector to display "GAME" on the main unit display. Then press and hold RETURN on the main unit for 3 seconds to switch the display to "DOCK".
Comments
0 comments
Please sign in to leave a comment.