TX-8260-Listening to the AM/FM Radio
You can receive AM/FM radio stations on this unit with the built-in tuner. Perform the following procedure when the unit is on.
Tuning into a Radio Station
Tuning Automatically
- Repeatedly press TUNER (a) on the remote controller and select "AM" or "FM".
- Press TUNING MODE on the main unit so that "TunMode: Auto" appears on the display.
- When you press the cursor Up/Down buttons (b) on the remote controller, automatic tuning starts, and searching stops when a station is found. When tuned into a radio station, the "TUNED" indicator on the display lights. When tuned into a stereo FM radio station, the "FM ST" indicator lights.
When FM broadcasts reception is poor:
Perform the procedure for "Tuning Manually" in the following section. Note that if you tune manually, the reception for FM broadcasts will be monaural rather than stereo, irrespective of the sensitivity of the reception.
Tuning Manually
If you tune manually, the reception for FM broadcasts will be monaural rather than stereo, irrespective of the sensitivity of the reception.
- Repeatedly press TUNER (a) on the remote controller and select "AM" or "FM".
- Press TUNING MODE on the main unit so that "TunMode: Manual" appears on the display.
- While pressing the cursor Up/Down buttons (b) on the remote controller, select the desired radio station.
- The frequency changes by 1 step each time you press Up/Down buttons. The frequency changes continuously if the button is held down and stops when the button is released.
Tuning into Stations by Frequency
It allows you to directly enter the frequency of the radio station you want to listen to.
- Press the TUNER button (a) of the remote controller repeatedly to select either "AM" or "FM".
- Press D.TUN button (c) on the remote controller.
- Using the number buttons (b) on the remote controller, enter the frequency of the radio station within 8 seconds.
- To enter 87.5 (FM), for example, press 8, 7, 5 or 8, 7, 5, 0. If the entered number is incorrect, press the D.TUN button again and re-enter the number.
Frequency Step Setting:
Press SETUP on the remote controller, then use the cursor buttons and ENTER on the remote controller to select "3. Hardware" - "AM/FM", and select the frequency step for your region. Note that when this setting is changed, all radio presets are deleted.
Comments
0 comments
Please sign in to leave a comment.