Setup

You have to change the setting on this unit if any of the connected speakers have 4 Ohms or more to less than 8 Ohms impedance. Change the speaker impedance setting to 4 Ohms.

Connect the Speaker Cables

Make correct connection between the unit’s jacks and speaker’s jacks (+ side to + side, and - side to - side) for each channel. If the connection is wrong, a bass sound will not be reproduced properly due to reverse phase. Twist the wires exposed from the tip of the speaker cable so that the wires do not stick out of the speaker terminal when connecting. If the exposed wires touch the rear panel, or the + side and - side wires touch each other, the protection circuit will be activated.

Note On Speaker Impedance

Connect speakers with an impedance of 4 Ohms to 16 Ohms.