INPUT LEVEL Knob Turn this INPUT LEVEL knob to adjust the input level of the signal from the INPUT jacks. Normally, set to MAX.
INPUT/OUTPUT Jacks These are the analog audio inputs and outputs. Use an RCA-type audio connection cable to connect the output jacks of the device to the INPUT jacks on the M-5010. When connecting a control amplifier or preamplifier, connect the PRE OUT jacks to the INPUT jacks.
If you connect the OUTPUT jacks of the M-5010 to the INPUT jacks of another M-5010, the signal input at the INPUT jacks of the M-5010 is also output from the OUTPUT jacks (Input/Output Link Function).
12V TRIGGER IN/OUT Jacks Connect the 12V TRIGGER IN jack to an AV Receiver that has a 12V TRIGGER output jack. This jack works on between 5 to 12 volts DC.
If you want another component to be activated/deactivated by turning on/off the AV receiver connected to the 12V TRIGGER IN jack of the M-5010, connect the 12V TRIGGER input jack of that component to the 12V TRIGGER OUT jack of the M-5010. In this state, the 12V TRIGGER is output when the M-5010 is turned on. Devices can be connected in series using these jacks.
Use 1/8-inch (3.5mm) monaural-type mini-jack connectors or the supplied stereo mini-plug cable. The tip polarity of the connector is positive.
SPEAKERS Terminals Connect Speakers.
TRIGGER Selector Set this TRIGGER switch before turning on the M-5010. To turn on the M-5010 with the signal input from the 12V TRIGGER IN jack, set the TRIGGER switch to 12V TRIGGER.
To turn on the M-5010 with the signal input from the INPUT jack, set the TRIGGER switch to AUDIO (Auto Power On Function). If you do not use Auto Power On Function, set the TRIGGER switch to OFF.
AUTO STANDBY Selector Enables or disables the Auto standby function.
SPEAKER IMPEDANCE Selector Switches the speaker impedance to 4 Ohms or 8 Ohms.
Comments
0 comments
Please sign in to leave a comment.