TX-NR696 - Rear Panel

1. DIGITAL IN OPTICAL/COAXIAL Jacks: Input TV or AV component digital audio signals with a digital optical cable or digital coaxial cable.

2. TUNER AM/FM Terminal: Connect the supplied antennas.

3. HDMI OUT Jacks: Transmit video signals and audio signals with an HDMI cable connected to a monitor such as a TV or projector.

4. Wireless Antenna: Used for WI-Fi connection or when using a BLUETOOTH enabled device. Adjust the angles according to the connection status.

5. HDMI IN Jacks: Transmit video signals and audio signals with an HDMI cable connected to an AV component.

6. ETHERNET Port: Connect to the network with a LAN cable.

7. USB Port: Connect a USB storage device to play music files.

• You can also supply power (5 V/1 A) to USB devices with a USB cable.

8. Power Cord (North American models)
AC INLET (European, Australian, Taiwanese and Asian models): Connect the supplied power cord.

9. GND Terminal: Connect the ground wire of the turntable.

10. AUDIO IN Jacks: Input AV component audio signals with an analog audio cable.

11. ZONE 2 LINE OUT Jacks: Output audio signals with an analog audio cable connected to a pre-main amplifier in a separate room (ZONE 2).
ZONE B LINE OUT Jacks: Connect to a pre-main amplifier with an analog audio cable, and simultaneously output audio of the same source as that of the speakers (ZONE A) connected to this unit.
PRE OUT FRONT jacks (European, Australian and Asian models): Connect to a power amplifier.

12. SUBWOOFER PRE OUT Jacks: Connect a powered subwoofer with a subwoofer cable.

• Up to two powered subwoofers can be connected.
• The same signal is output from each SUBWOOFER PRE OUT jack.

13. SPEAKERS Terminals: Connect speakers with speaker cables.

• (North American models support banana plugs. Use a plug 4 mm in diameter. Y plug connection is not supported.)